Subject	use your vice and bend that rod!
Posted by	fuzzymonkey on July 27, 2012 at 4:13 PM
	This message has been viewed 178 times.
In Reply To	What are NA>TT guys doing for the hood prop support? posted by PiotrC70 on July 27, 2012 at 03:24 PM
Message	then get the $2 white clip and it'll fit...in a bit of an angle, but close enough. I had the same issue with my Koyo. Also, my czp rad bracket (the full long one, not two pieces like yours) had issues fitting properly. Car used to be AT? Maybe compatibility issues there as well?
Follow Ups	What are NA>TT guys doing for the hood prop support? - PiotrC70 15:24:45 07/27/12 You can fit the tab between the shroud & radiator. - Bernie (NoVA) 15:30:27 07/27/12 simple fix. Have the tabs cut off and rewelded in the TT - Red Hawk (CO) 15:43:18 07/27/12 My WinFactory kit has grown on me. It is a must now. =) (n/m) - evan_aggie 22:36:07 07/27/12 use your vice and bend that rod! - fuzzymonkey 16:13:21 07/27/12 This. Did the same thing, works great, Basically TT prop now (n/m) - ZinnZ32 17:38:09 07/27/12 I have the one piece CZP on all my cars. You are right ... - ConVerTT 17:27:54 07/27/12 Old pic but you get the idea - ConVerTT 17:36:39 07/27/12 I rarely post in the General forum... - MegaZ 20:30:04 07/27/12 Thanks, but I'm definitely looking at a 2pc design. I think - PiotrC70 23:32:03 07/27/12 wow.... motor is looking awesome Piotr!! (n/m) - rave 09:10:34 07/28/12 Thanks! One of these days, I'll make it down to Portland... - PiotrC70 10:26:41 07/28/12 trim the rails on the radiator and switch R to L brackets? (n/m) - LitlElvis 10:52:14 07/28/12 I got the the win factory strut (n/m) - BlackholeZ 11:41:49 07/28/12 Buy a bracket for the rad and the hood prop clip - John (MD) 10:07:07 07/29/12
Post a Followup	You cannot reply to this message because you are not logged in.