Subject	I just did the mod and didn't have to cust as much off. Most
Posted by	PiotrC70 on July 04, 2012 at 1:06 PM
	This message has been viewed 75 times.
In Reply To	I don't want to cut that much off of my sidemarkers!!! (n/m) posted by BoneZ (MD) on July 02, 2012 at 09:59 PM
Message	of the clearance needed is where the connector is. 1993 TT. R.I.P. 09.15.2010
Follow Ups	any solution for turn signal fitment with Ashspec fmic ? - ztunerz 02:49:31 07/02/12 *SMIC. Seal the stock opening & cut new one in side of - Bernie (NoVA) 02:55:50 07/02/12 smic- sorry 4 am :), what about that reflector ? (n/m) - ztunerz 02:59:18 07/02/12 found it ty, looks like he cut thru the reflector (n/m) - ztunerz 03:04:58 07/02/12 That doesn't work if you have the IC ducts. I haven't done - PiotrC70 09:48:01 07/02/12 Depends on the version. The earlier versions worked fine - MixManMash 10:07:07 07/02/12 I purchased my ducts around same time last year so - PiotrC70 12:02:47 07/02/12 I don't want to cut that much off of my sidemarkers!!! (n/m) - BoneZ (MD) 21:59:13 07/02/12 I just did the mod and didn't have to cust as much off. Most - PiotrC70 13:06:22 07/04/12 Here>> - Spongerider :) 13:15:54 07/02/12 Could make them into ducts as I did - 91Z32TT 10:26:42 07/03/12
Post a Followup	You cannot reply to this message because you are not logged in.