Subject	Here>>
Posted by	Spongerider :) on July 02, 2012 at 1:15 PM
	This message has been viewed 134 times.
In Reply To	any solution for turn signal fitment with Ashspec fmic ? posted by ztunerz on July 02, 2012 at 02:49 AM
Message	[ http://www.stillensucks.com/Z32/Clearcorner_Modification/clearcornermod.html ] www.SoCalZCrew.com Quote, ni[X]it 12:45:09 03/14/09, "this message has been posted under pressure of my peers, and therefore may not represent my actual thoughts of the improper use of carbon faggot. then again, it just might." **Dynoed at 371.2 rwhp. and 362.3 rwtrq. @ .9 bar on pumped 91 gas 3/11/03** **Dynoed at 411 rwhp. and 452 rwtq. @1.15 kg. on race gas 104 3/28/03 **All numbers are SAE corrected**
Follow Ups	any solution for turn signal fitment with Ashspec fmic ? - ztunerz 02:49:31 07/02/12 *SMIC. Seal the stock opening & cut new one in side of - Bernie (NoVA) 02:55:50 07/02/12 smic- sorry 4 am :), what about that reflector ? (n/m) - ztunerz 02:59:18 07/02/12 found it ty, looks like he cut thru the reflector (n/m) - ztunerz 03:04:58 07/02/12 That doesn't work if you have the IC ducts. I haven't done - PiotrC70 09:48:01 07/02/12 Depends on the version. The earlier versions worked fine - MixManMash 10:07:07 07/02/12 I purchased my ducts around same time last year so - PiotrC70 12:02:47 07/02/12 I don't want to cut that much off of my sidemarkers!!! (n/m) - BoneZ (MD) 21:59:13 07/02/12 I just did the mod and didn't have to cust as much off. Most - PiotrC70 13:06:22 07/04/12 Here>> - Spongerider :) 13:15:54 07/02/12 Could make them into ducts as I did - 91Z32TT 10:26:42 07/03/12
Post a Followup	You cannot reply to this message because you are not logged in.