Subject	The purpose of the o-ring is to keep the sleeves in place
Posted by	boileralum on July 01, 2012 at 4:07 PM
	This message has been viewed 143 times.
In Reply To	KYB + Ground Control assembly questions posted by nicky_z32 on July 01, 2012 at 11:07 AM
Message	and to keep them from rattling. Rule #1 - There's always a bastard!
Follow Ups	KYB + Ground Control assembly questions - nicky_z32 11:07:41 07/01/12 The purpose of the o-ring is to keep the sleeves in place - boileralum 16:07:46 07/01/12 There's mixed info on these out there. - Jayru 19:29:30 07/01/12 Thanx, will do. I think the sleeves should go lower and fit - nicky_z32 19:46:47 07/01/12 also.... - Halo TTZ 20:15:04 07/01/12 Thanx, yeah I noticed that too. I have to grind down some of - nicky_z32 20:34:16 07/01/12 Did you modify/use the stock rubber bump stops? (n/m) - nicky_z32 20:37:55 07/01/12 it was like 10 years ago, but I think so... at least i tried - Halo TTZ 21:01:12 07/01/12 Stock bump stops must be cut in half IIRC (n/m) - Jayru 23:02:25 07/01/12
Post a Followup	You cannot reply to this message because you are not logged in.