Subject	If the Brembo rotors will do the trick w/o warping, then
Posted by	Vert93 (MN) on June 25, 2012 at 5:00 PM
	This message has been viewed 124 times.
In Reply To	If you are planning on selling then replace w. stock posted by Bernie (NoVA) on June 25, 2012 at 04:53 PM
Message	I'll get them, Bernie. I assume you are suggesting that cryotreating will not be necessary? I just don't want to have to do this again.
Follow Ups	Brake rotor advice. - Vert93 (MN) 16:45:37 06/25/12 If you are planning on selling then replace w. stock - Bernie (NoVA) 16:53:47 06/25/12 If the Brembo rotors will do the trick w/o warping, then - Vert93 (MN) 17:00:42 06/25/12 He's saying since you plan on selling, replace with a - samsung-Z [Houston] 18:08:03 06/25/12 Actually, it was Stop Tech brake pads, not Hawk HPS... (n/m) - Vert93 (MN) 16:54:22 06/25/12 ...and stop beating on it. (n/m) - Bernie (NoVA) 02:02:40 06/26/12 the stock sized rotors are too small for that much power - moxie (SF) 18:24:07 06/25/12 Im running the stocksize stoptech rotors that IPP sells - black300zx 19:30:06 06/25/12 the weight is only half the issue. The power plays - moxie (SF) 19:34:44 06/25/12 What 15" wheels are you using? (n/m) - Fast300 20:03:37 06/25/12 Whoops - 245/45/16. 16x8.5 TT stockers front & rear (n/m) - black300zx 20:46:15 06/25/12 I had great results with ATE rotors with the stock size. - ShakaShaun(Denver) 20:16:38 06/25/12 Thanks for all of the suggestions. Hopefully one of them - Vert93 (MN) 08:36:12 06/26/12 You don't seem to be bedding them in and I agree w. TDogg (n/m) - Bernie (NoVA) 09:14:11 06/26/12 The rotors didn't warp, you had uneven pad deposits. - BigTDogg (MA) 09:07:22 06/26/12 Tony is right, you wont warp the stock discs, the fluid will - LJZTT 10:03:34 06/26/12 I'll third what Tony said - what was your bed-in procedure? - black300zx 16:29:11 06/26/12 key is don't stop until you can smell them from inside (n/m) - LJZTT 16:59:22 06/26/12 oh I was smelling em alright! (n/m) - black300zx 18:27:26 06/26/12
Post a Followup	You cannot reply to this message because you are not logged in.