Subject	took 4 hrs but wasnt anywhere as bad
Posted by	nissan300zxwork on June 12, 2012 at 8:07 PM
	This message has been viewed 100 times.
In Reply To	efi swap with motor in posted by nissan300zxwork on June 11, 2012 at 06:21 PM
Message	I worked at slow pace and took half plenum apart for no reason and had to soldier the injectors clips in. I disconnected all harness and then took off first couple harness holders closest to brake booster, then cut the harness where it goes into firewall and then grabbed harness near the booster and pulled it out. Looks more intimating than actual wor.
Follow Ups	efi swap with motor in - nissan300zxwork 18:21:43 06/11/12 Talking about the harness swap? - Draker (Eugene, OR) 18:37:48 06/11/12 Can be done, not easy. You can do it. Easier to pull the - CmyZ 19:12:47 06/11/12 I did this before - RonDeezy 20:18:24 06/11/12 Re: I did this before - nissan300zxwork 20:24:30 06/11/12 No need to pull plenum - but helps to drop trans. (n/m) - Bernie (NoVA) 11:04:29 06/12/12 Just did that this weekend... - HK'S Z 13:59:12 06/12/12 Removing the baffle under the dash will help 100% - CoHPhasor 19:37:16 06/12/12 i depined small clip. wasnt bad. (n/m) - nissan300zxwork 20:09:39 06/12/12 took 4 hrs but wasnt anywhere as bad - nissan300zxwork 20:07:44 06/12/12 If I had to do it again, I'd pull the motor was huge PITA - LJZTT 06:56:43 06/13/12
Post a Followup	You cannot reply to this message because you are not logged in.