Subject	Removing the baffle under the dash will help 100%
Posted by	CoHPhasor on June 12, 2012 at 7:37 PM
	This message has been viewed 243 times.
In Reply To	efi swap with motor in posted by nissan300zxwork on June 11, 2012 at 06:21 PM
Message	The reason why most guys have to "de-pin" the connector is there is a baffle under the dash that makes a choke point at the firewall. If remove/cut the baffle it'll slide out like butter. (Also doesn't help that the silly black foam is in the way) "Is this why my car sounds like a skeleton jacking off?" > blackomega
Follow Ups	efi swap with motor in - nissan300zxwork 18:21:43 06/11/12 Talking about the harness swap? - Draker (Eugene, OR) 18:37:48 06/11/12 Can be done, not easy. You can do it. Easier to pull the - CmyZ 19:12:47 06/11/12 I did this before - RonDeezy 20:18:24 06/11/12 Re: I did this before - nissan300zxwork 20:24:30 06/11/12 No need to pull plenum - but helps to drop trans. (n/m) - Bernie (NoVA) 11:04:29 06/12/12 Just did that this weekend... - HK'S Z 13:59:12 06/12/12 Removing the baffle under the dash will help 100% - CoHPhasor 19:37:16 06/12/12 i depined small clip. wasnt bad. (n/m) - nissan300zxwork 20:09:39 06/12/12 took 4 hrs but wasnt anywhere as bad - nissan300zxwork 20:07:44 06/12/12 If I had to do it again, I'd pull the motor was huge PITA - LJZTT 06:56:43 06/13/12
Post a Followup	You cannot reply to this message because you are not logged in.