Subject	Can be done, not easy. You can do it. Easier to pull the
Posted by	CmyZ on June 11, 2012 at 7:12 PM
	This message has been viewed 265 times.
In Reply To	efi swap with motor in posted by nissan300zxwork on June 11, 2012 at 06:21 PM
Message	engine like draker wrote. You can attempt it by loosening the front cross member and shocks from the shock towers, but make sure you support them properly. If you need to do injector work and pull the upper plenum/intake. This will give you a fighting chance to replace it.Then you will need an alignment. Not easy though. ...I've done it a couple of times. Not my preference.
Follow Ups	efi swap with motor in - nissan300zxwork 18:21:43 06/11/12 Talking about the harness swap? - Draker (Eugene, OR) 18:37:48 06/11/12 Can be done, not easy. You can do it. Easier to pull the - CmyZ 19:12:47 06/11/12 I did this before - RonDeezy 20:18:24 06/11/12 Re: I did this before - nissan300zxwork 20:24:30 06/11/12 No need to pull plenum - but helps to drop trans. (n/m) - Bernie (NoVA) 11:04:29 06/12/12 Just did that this weekend... - HK'S Z 13:59:12 06/12/12 Removing the baffle under the dash will help 100% - CoHPhasor 19:37:16 06/12/12 i depined small clip. wasnt bad. (n/m) - nissan300zxwork 20:09:39 06/12/12 took 4 hrs but wasnt anywhere as bad - nissan300zxwork 20:07:44 06/12/12 If I had to do it again, I'd pull the motor was huge PITA - LJZTT 06:56:43 06/13/12
Post a Followup	You cannot reply to this message because you are not logged in.