Subject	Daniel from Z1 had mentioned that grooves were
Posted by	JMartz on June 11, 2012 at 12:31 PM
	This message has been viewed 130 times.
In Reply To	I'm installing a set for a customer posted by aliaZ on June 11, 2012 at 10:50 AM
Message	cut in the bushings to hold grease and eliminate squeaking. I wonder how the grease was supposed to get in those grooves. They must be pre greased during manufacturing if grease cups are not installed.
Follow Ups	Z1 Adjustable Upper Control Arms - JMartz 09:20:15 06/11/12 We've sold over 15 sets in two weeks. I hope someone - John@Z1 10:19:17 06/11/12 potential squeaking - JMartz 11:46:47 06/11/12 I'm installing a set for a customer - aliaZ 10:50:36 06/11/12 We haven't heard from this customer, can you have him call - John@Z1 11:04:39 06/11/12 the customer isn't aware yet - aliaZ 12:46:50 06/11/12 Was it something that you noticed just articulating... - Spencer@Z1 13:04:30 06/11/12 yep, just articulating - aliaZ 13:11:33 06/11/12 Daniel from Z1 had mentioned that grooves were - JMartz 12:31:50 06/11/12 Re: Daniel from Z1 had mentioned that grooves were - Spencer@Z1 13:01:05 06/11/12 the problem is the pin is so smooth that when you press it - aliaZ 13:08:07 06/11/12 Lol. - MixManMash 13:24:18 06/11/12 Thanks for the input, - Spencer@Z1 13:38:09 06/11/12 fwiw - aliaZ 16:32:32 06/11/12 I notice a lot of people say their ES bushings squeak after - ZXoltan 00:16:37 06/12/12 Adjustable FUCA's are doomed for failure. - RevTech 15:17:32 06/12/12 not necessarily (n/m) - aliaZ 17:27:58 06/12/12
Post a Followup	You cannot reply to this message because you are not logged in.