Subject	I swapped MT cams in when I had everything apart >>
Posted by	my91z on June 05, 2012 at 5:54 PM
	This message has been viewed 188 times.
In Reply To	Thought of switching to MT Cams. Worth it? posted by LivinTheDream on June 05, 2012 at 11:35 AM
Message	during my build. I went ahead and replaced the valve stem seals as well when I had the cams out since I had some oil dampness in a couple exhaust ports. Don't have any baseline to compare power to, but when I had AT cams you could feel the power drop off at high rpms, almost like it wasn't worth revving out. Engine pulls all the way up now. Lots of other things are different now so I can't say it was just the cams. Mike --------------------------------------------------------
Follow Ups	Thought of switching to MT Cams. Worth it? - LivinTheDream 11:35:07 06/05/12 I don't think the gain would justify the effort needed to do - DVDBURN (MD) 11:48:29 06/05/12 ^this (n/m) - Madhatter10-6 12:14:29 06/05/12 2nd. Unless you have the cams sitting around and - MixManMash 12:23:58 06/05/12 If you have them, since its apart. Otherwise, nope. (n/m) - HillZTT 13:09:17 06/05/12 Assuming you find some cheap cams in good condition - MrOzzie5183 15:50:13 06/05/12 It probably needs adjustable cam gears to get the most out - MixManMash 16:35:36 06/05/12 What about using 90-93 JWT Mild 100 Series, S1 Cams? - Z-speed 16:54:13 06/05/12 These cams are not that good. They are regrinds. - MixManMash 18:01:33 06/05/12 JWT S1 cams lose power? - Z-speed 20:09:31 06/05/12 Call Specialty Z and ask. (n/m) - MixManMash 00:08:33 06/06/12 This is true, the regrind are supposedly ok for the na - HighPsi (NorCal) 00:27:52 06/06/12 I swapped MT cams in when I had everything apart >> - my91z 17:54:35 06/05/12 Thanks guys. Think I'll pass. Don't have them on hand. - LivinTheDream 21:40:14 06/05/12
Post a Followup	You cannot reply to this message because you are not logged in.