Subject	Good to know...
Posted by	tiale11 on May 24, 2012 at 12:40 PM
	This message has been viewed 90 times.
In Reply To	I recently installed a Z1 full flow oil cooler setup posted by aliaZ on May 24, 2012 at 06:52 AM
Message	I was just about to upgrade to the B&M 70264 and keeping the OEM oil bypass for track use... Did he mention any increase in oil pressure after the full flow cooler?
Follow Ups	Looking for information with cooling upgrades - pearlzed(toronto) 22:12:06 05/23/12 My opinion - Drk93TT 23:12:09 05/23/12 I recently installed a Z1 full flow oil cooler setup - aliaZ 06:52:30 05/24/12 I thought a few folks were worried abt low oil pressure at start - evan_aggie(ATX) 11:05:03 05/24/12 If you have a thermostatic sandwich plate adap, you're fine (n/m) - ZinnZ32 11:19:10 05/24/12 why would that matter? (n/m) - aliaZ 14:53:29 05/24/12 Good to know... - tiale11 12:40:12 05/24/12 oil pressure was better - aliaZ 14:57:27 05/24/12
Post a Followup	You cannot reply to this message because you are not logged in.