Subject	I thought a few folks were worried abt low oil pressure at start
Posted by	evan_aggie(ATX) on May 24, 2012 at 11:05 AM
	This message has been viewed 102 times.
In Reply To	I recently installed a Z1 full flow oil cooler setup posted by aliaZ on May 24, 2012 at 06:52 AM
Message	I doubt the concern, but did it cross your mind?
Follow Ups	Looking for information with cooling upgrades - pearlzed(toronto) 22:12:06 05/23/12 My opinion - Drk93TT 23:12:09 05/23/12 I recently installed a Z1 full flow oil cooler setup - aliaZ 06:52:30 05/24/12 I thought a few folks were worried abt low oil pressure at start - evan_aggie(ATX) 11:05:03 05/24/12 If you have a thermostatic sandwich plate adap, you're fine (n/m) - ZinnZ32 11:19:10 05/24/12 why would that matter? (n/m) - aliaZ 14:53:29 05/24/12 Good to know... - tiale11 12:40:12 05/24/12 oil pressure was better - aliaZ 14:57:27 05/24/12
Post a Followup	You cannot reply to this message because you are not logged in.