Subject	I was actually thinking of doing bearings
Posted by	BlackholeZ on May 23, 2012 at 8:26 PM
	This message has been viewed 161 times.
In Reply To	Is this going to be the next great Blackhole Z product? posted by ZXoltan on May 23, 2012 at 09:44 AM
Message	this was more of a quickie idea. To be honest bearings are quite a bit overkill. I can't speak to the quality or resulting throws of the Z1 because I haven't had it in my hands. It was a bit of a pita getting things to fit right on this go. It might be because the tube on the base of shifter isn't quite straight/round. At the moment there was too much work involved to get it to work properly to send parts to someone and expect it to be plug and play. I need to work on the lifted mount and try it in a few cars before I know if this would be sellable. -Dan BlackholeZ VTC Solenoid Caps and Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines " You're the Skrillex of Z32s." BradX (UF)
Follow Ups	Tightening shift throw and better bushings - BlackholeZ 19:56:44 05/22/12 Is this going to be the next great Blackhole Z product? - ZXoltan 09:44:04 05/23/12 I was actually thinking of doing bearings - BlackholeZ 20:26:09 05/23/12
Post a Followup	You cannot reply to this message because you are not logged in.