Subject	RE:...stay steady when it is in closed position?
Posted by	Ba11erz (MD) on May 22, 2012 at 10:48 PM
	This message has been viewed 141 times.
In Reply To	TPS voltage Q. posted by MaxxAction on May 22, 2012 at 09:20 PM
Message	Yes! Experienced the same issues with one of my Z1 TBs until I sent (at least the problematic TB) it out to @RobZ 90TT for prepeller correction. They were not closing fully. :( Had to occassionally "blip" the throttle to force them to close completely. It's an easy fix. :) They just have to be honed a bit to ensure they close ccompletely. I'm just guessing this is your problem and one way to fix them [if] they don't appear to close fully. I suggest you pull them off and check closly to determine if that is the case. Or try another TPS. Good luck!
Follow Ups	TPS voltage Q. - MaxxAction 21:20:26 05/22/12 Re: TPS voltage Q. - MaxxAction 21:22:14 05/22/12 RE:...stay steady when it is in closed position? - Ba11erz (MD) 22:48:31 05/22/12 If the throttle body shaft is loose, then you might see - Gordo 93TT Daytona 09:58:20 05/23/12 Re: If the throttle body shaft is loose, then you might see - MaxxAction 10:41:27 05/23/12 Everything is relative. I'd like you to see 4.0-5.0 volts - Gordo 93TT Daytona 12:53:42 05/23/12 Re: Everything is relative. I'd like you to see 4.0-5.0 volts - MaxxAction 14:59:21 05/23/12 The Idle Switch sets most of the parameters for engine - Gordo 93TT Daytona 15:54:13 05/23/12 Re: The Idle Switch sets most of the parameters for engine - MaxxAction 21:10:03 05/23/12 Tech Forum (n/m) - OverZealous (CT) 14:41:29 05/23/12
Post a Followup	You cannot reply to this message because you are not logged in.