Subject	Mine came with stock exhaust gaskets. (n/m)
Posted by	ZaXxon on May 20, 2012 at 8:59 PM
	This message has been viewed 84 times.
In Reply To	Was thinking the same thing during my build. I was a bit posted by PiotrC70 on May 20, 2012 at 07:37 PM
Message
Follow Ups	What is the consensus on port matching the exhuast ports.... - ZaXxon 07:18:00 05/20/12 The idea is to port just up to the gasket margins (n/m) - ZXoltan 07:57:03 05/20/12 Probably is not a bad idea... - KongZTT GT28RS MD 14:27:25 05/20/12 I was told that the head's port should be slightly smaller - Dark Diver 15:33:55 05/20/12 if you port match, be careful. - spyhunterTT(md) 15:50:19 05/20/12 What did you do for gaskets? modify stock? (n/m) - ZaXxon 16:13:53 05/20/12 Was thinking the same thing during my build. I was a bit - PiotrC70 19:37:39 05/20/12 Mine came with stock exhaust gaskets. (n/m) - ZaXxon 20:59:44 05/20/12 Piotr- Your gasket was bigger or was not much bigger - ZXoltan 07:51:02 05/21/12 Sorry... not much bigger than the MSP's. If I recall, - PiotrC70 08:51:36 05/22/12
Post a Followup	You cannot reply to this message because you are not logged in.