Subject	if you port match, be careful.
Posted by	spyhunterTT(md) on May 20, 2012 at 3:50 PM
	This message has been viewed 153 times.
In Reply To	What is the consensus on port matching the exhuast ports.... posted by ZaXxon on May 20, 2012 at 07:18 AM
Message	If you bring them up to the MSP size (my heads are close to it), you will be very close to the various oil and watch jackets in the heads. There's a lot of material to remove if you choose to go this route. Alex src="http://www.photodump.org/stored18/sig_pic_spyhunter ttnj.jpg">
Follow Ups	What is the consensus on port matching the exhuast ports.... - ZaXxon 07:18:00 05/20/12 The idea is to port just up to the gasket margins (n/m) - ZXoltan 07:57:03 05/20/12 Probably is not a bad idea... - KongZTT GT28RS MD 14:27:25 05/20/12 I was told that the head's port should be slightly smaller - Dark Diver 15:33:55 05/20/12 if you port match, be careful. - spyhunterTT(md) 15:50:19 05/20/12 What did you do for gaskets? modify stock? (n/m) - ZaXxon 16:13:53 05/20/12 Was thinking the same thing during my build. I was a bit - PiotrC70 19:37:39 05/20/12 Mine came with stock exhaust gaskets. (n/m) - ZaXxon 20:59:44 05/20/12 Piotr- Your gasket was bigger or was not much bigger - ZXoltan 07:51:02 05/21/12 Sorry... not much bigger than the MSP's. If I recall, - PiotrC70 08:51:36 05/22/12
Post a Followup	You cannot reply to this message because you are not logged in.