Subject	What is the consensus on port matching the exhuast ports....
Posted by	ZaXxon on May 20, 2012 at 7:18 AM
	This message has been viewed 191 times.
Message	with the MSP manifolds? If this is the way to go, then what are people doing for exhaust gaskets. Fabricated gaskets? Modifying the stock gaskets? I apologize if this has been covered, but I couldn't find it after searching. Thanks.
Follow Ups	What is the consensus on port matching the exhuast ports.... - ZaXxon 07:18:00 05/20/12 The idea is to port just up to the gasket margins (n/m) - ZXoltan 07:57:03 05/20/12 Probably is not a bad idea... - KongZTT GT28RS MD 14:27:25 05/20/12 I was told that the head's port should be slightly smaller - Dark Diver 15:33:55 05/20/12 if you port match, be careful. - spyhunterTT(md) 15:50:19 05/20/12 What did you do for gaskets? modify stock? (n/m) - ZaXxon 16:13:53 05/20/12 Was thinking the same thing during my build. I was a bit - PiotrC70 19:37:39 05/20/12 Mine came with stock exhaust gaskets. (n/m) - ZaXxon 20:59:44 05/20/12 Piotr- Your gasket was bigger or was not much bigger - ZXoltan 07:51:02 05/21/12 Sorry... not much bigger than the MSP's. If I recall, - PiotrC70 08:51:36 05/22/12
Post a Followup	You cannot reply to this message because you are not logged in.