Subject	Ha , I like that ^^^ (n/m)
Posted by	Xteam300TT (South Tx ) on May 18, 2012 at 10:41 PM
	This message has been viewed 142 times.
In Reply To	I've seen plenty of chipped stock balancers that never had posted by aliaZ on May 18, 2012 at 07:20 PM
Message
Follow Ups	ATI Dampner WTF - ouikikazz 17:19:56 05/18/12 It may throw the balance off.. but its so small.. - KongZTT GT28RS MD 17:28:09 05/18/12 Should be fine. - ZXoltan 18:08:06 05/18/12 ***should*** be fine wouldn't sit comfortably with me - fuzzymonkey 18:22:49 05/18/12 I've seen plenty of chipped stock balancers that never had - aliaZ 19:20:01 05/18/12 Ha , I like that ^^^ (n/m) - Xteam300TT (South Tx ) 22:41:11 05/18/12 Re: ATI Dampner WTF - MaxxAction 18:35:21 05/18/12 Or you can use a small film of anti-seize (n/m) - KongZTT GT28RS MD 18:50:23 05/18/12 2nd (n/m) - aliaZ 19:17:34 05/18/12 Re: Or you can use a small film of anti-seize - MaxxAction 19:21:47 05/18/12 Highly doubt you caused any issue. I don't think that could - Jkova300z 18:36:33 05/18/12 no you can't balance an ATI - aliaZ 19:17:09 05/18/12 I think you contradicted this statement up above, Don :-P (n/m) - ZXoltan 06:51:53 05/19/12 A ATI damper is pressed fit, Which makes it a PITA to remove - toykoz32 20:25:24 05/18/12 Re: A ATI damper is pressed fit, Which makes it a PITA to remove - ouikikazz 21:30:56 05/18/12 That one pictured didn't come with the correct bolt either - toykoz32 21:58:05 05/18/12 Re: That one pictured didn't come with the correct bolt either - ouikikazz 22:09:03 05/18/12 You could grind off a similar amount on the other side if it - turtleboy 22:15:30 05/18/12 Thats just silly (n/m) - toykoz32 23:02:39 05/18/12
Post a Followup	You cannot reply to this message because you are not logged in.