Subject	Re: Or you can use a small film of anti-seize
Posted by	MaxxAction on May 18, 2012 at 7:21 PM
	This message has been viewed 252 times.
In Reply To	Or you can use a small film of anti-seize (n/m) posted by KongZTT GT28RS MD on May 18, 2012 at 06:50 PM
Message	According to the tech I spoke to at ATI... anti seize won't work unless you have that .006" clearance. I called them because I broke one puller trying to get it off, and rounded the tip off of another. Finally some heat got it to break loose. When I called them, they told me it is in the instructions to make sure the tolerance (006")is right.
Follow Ups	ATI Dampner WTF - ouikikazz 17:19:56 05/18/12 It may throw the balance off.. but its so small.. - KongZTT GT28RS MD 17:28:09 05/18/12 Should be fine. - ZXoltan 18:08:06 05/18/12 ***should*** be fine wouldn't sit comfortably with me - fuzzymonkey 18:22:49 05/18/12 I've seen plenty of chipped stock balancers that never had - aliaZ 19:20:01 05/18/12 Ha , I like that ^^^ (n/m) - Xteam300TT (South Tx ) 22:41:11 05/18/12 Re: ATI Dampner WTF - MaxxAction 18:35:21 05/18/12 Or you can use a small film of anti-seize (n/m) - KongZTT GT28RS MD 18:50:23 05/18/12 2nd (n/m) - aliaZ 19:17:34 05/18/12 Re: Or you can use a small film of anti-seize - MaxxAction 19:21:47 05/18/12 Highly doubt you caused any issue. I don't think that could - Jkova300z 18:36:33 05/18/12 no you can't balance an ATI - aliaZ 19:17:09 05/18/12 I think you contradicted this statement up above, Don :-P (n/m) - ZXoltan 06:51:53 05/19/12 A ATI damper is pressed fit, Which makes it a PITA to remove - toykoz32 20:25:24 05/18/12 Re: A ATI damper is pressed fit, Which makes it a PITA to remove - ouikikazz 21:30:56 05/18/12 That one pictured didn't come with the correct bolt either - toykoz32 21:58:05 05/18/12 Re: That one pictured didn't come with the correct bolt either - ouikikazz 22:09:03 05/18/12 You could grind off a similar amount on the other side if it - turtleboy 22:15:30 05/18/12 Thats just silly (n/m) - toykoz32 23:02:39 05/18/12
Post a Followup	You cannot reply to this message because you are not logged in.