Subject	Should be fine.
Posted by	ZXoltan on May 18, 2012 at 6:08 PM
	This message has been viewed 199 times.
In Reply To	It may throw the balance off.. but its so small.. posted by KongZTT GT28RS MD on May 18, 2012 at 05:28 PM
Message	Does it have any threaded holes for a HB puller? The stock pulley has two threaded holes for a puller.
Follow Ups	ATI Dampner WTF - ouikikazz 17:19:56 05/18/12 It may throw the balance off.. but its so small.. - KongZTT GT28RS MD 17:28:09 05/18/12 Should be fine. - ZXoltan 18:08:06 05/18/12 ***should*** be fine wouldn't sit comfortably with me - fuzzymonkey 18:22:49 05/18/12 I've seen plenty of chipped stock balancers that never had - aliaZ 19:20:01 05/18/12 Ha , I like that ^^^ (n/m) - Xteam300TT (South Tx ) 22:41:11 05/18/12 Re: ATI Dampner WTF - MaxxAction 18:35:21 05/18/12 Or you can use a small film of anti-seize (n/m) - KongZTT GT28RS MD 18:50:23 05/18/12 2nd (n/m) - aliaZ 19:17:34 05/18/12 Re: Or you can use a small film of anti-seize - MaxxAction 19:21:47 05/18/12 Highly doubt you caused any issue. I don't think that could - Jkova300z 18:36:33 05/18/12 no you can't balance an ATI - aliaZ 19:17:09 05/18/12 I think you contradicted this statement up above, Don :-P (n/m) - ZXoltan 06:51:53 05/19/12 A ATI damper is pressed fit, Which makes it a PITA to remove - toykoz32 20:25:24 05/18/12 Re: A ATI damper is pressed fit, Which makes it a PITA to remove - ouikikazz 21:30:56 05/18/12 That one pictured didn't come with the correct bolt either - toykoz32 21:58:05 05/18/12 Re: That one pictured didn't come with the correct bolt either - ouikikazz 22:09:03 05/18/12 You could grind off a similar amount on the other side if it - turtleboy 22:15:30 05/18/12 Thats just silly (n/m) - toykoz32 23:02:39 05/18/12
Post a Followup	You cannot reply to this message because you are not logged in.