Subject	Did i just turn my SPL radiator into a $500 paperweight?
Posted by	Jayru on May 18, 2012 at 2:37 PM
	This message has been viewed 925 times.
Message	I swear this car is fighting me tooth and nail to not ever be fixed... Accidentally tapped the trans with my jack handle sending it toppeling over right into my SPL radiator :-( 90 Twin Turbo Track Build - jsworks.org for more info!
Follow Ups	Did i just turn my SPL radiator into a $500 paperweight? - Jayru 14:37:29 05/18/12 Is it leaking? (n/m) - JonnyZ(SoCal) 14:40:27 05/18/12 No fluid in it, it was never even installed yet. - Jayru 14:44:24 05/18/12 yep - aliaZ 14:44:17 05/18/12 blame it on fedex (n/m) - fuzzymonkey 14:47:13 05/18/12 fail (n/m) - moxie (SF) 15:26:07 05/18/12 Too big a paperweight for my desk. Your's must be huge. (n/m) - treese88 14:50:17 05/18/12 you can cut both end tanks off & TIG those tubes closed. (n/m) - induetime 14:53:16 05/18/12 just curious where did you purchase it ? - ZWolf 15:14:59 05/18/12 Was the last one and Sean's (SPL) personal one - Jayru 15:39:23 05/18/12 Another discontinued SPL product? That sucks... (n/m) - Inzane 21:02:15 05/18/12 This build has been nothing but disasters from day one... - Jayru 15:36:48 05/18/12 Happens to all of us - Pilot.P 03:54:55 05/19/12 Can be fixed by experience radiator shop - OverZealous (CT) 15:36:48 05/18/12 I think you can get $1.14 a LB (n/m) - njz 15:47:20 05/18/12 lol (n/m) - ForceFedTT (SoCal) 04:35:10 05/19/12 Call a radiator shop. They can this it I'm sure. (n/m) - Draker (Eugene, OR) 16:24:13 05/18/12 Fixable....I've seen worst getting fixed. Just take it to a - TheTwinZ (Peru) 19:06:14 05/18/12 Call Bryan McCulloch, he built the rad, I'm sure he can - zgene4 19:28:34 05/18/12 yep (n/m) - aliaZ 23:09:04 05/18/12 Thanks guys for all the advice! - Jayru 19:29:44 05/18/12 Let us know how much$$$$ to repair (n/m) - njz 10:31:04 05/19/12 I would be so pissed. That sucks bro. (n/m) - Antihero 19:50:13 05/18/12 Just put some JB weld on it, it will be fine lol (n/m) - Gennosuke 20:50:17 05/18/12 This actually is a proven solution to these problems (n/m) - OverZealous (CT) 21:59:18 05/19/12 Yup, repairing aircraft heat exchangers we used epoxy - BlackholeZ 20:10:46 05/20/12 That can be fixed by a good Tig welder. (n/m) - Timmay 02:20:35 05/19/12
Post a Followup	You cannot reply to this message because you are not logged in.