TwinTurbo.NET: Nissan 300ZX forum - Realize that most injector companies suck at matching
People Seeking Info
 
   


     
Subject Realize that most injector companies suck at matching
     
Posted by CoHPhasor on May 15, 2012 at 6:25 PM
  This message has been viewed 385 times.
     
In Reply To Deatschwerks injectors flow sheets are incorrect posted by hellraz0r1337 on May 15, 2012 at 04:04 PM
     
Message The sad truth is that it is hard to flow-match a set very well if you aren't using the most precise internals possible.

When most places flow match they only test in 1, 2, or 3 places in their range, not the entirety.

This is exactly why I went with Injector Dynamics top-feeds.
The cost was comparable, even with having to get a whole new railset.
I.D. are matched across a much wider set of points.

In any case, DW suck, period, I wish someone would learn the lesson and stop gambling like this.

("A few are doing fine!" is a terrible excuse to gamble with your money)

"Is this why my car sounds like a skeleton jacking off?" > blackomega

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.