Subject	yes, your local guy is correct
Posted by	LJZTT on May 14, 2012 at 2:34 PM
	This message has been viewed 131 times.
In Reply To	Eastwood Fender Roller ??? posted by blackomega on May 14, 2012 at 11:17 AM
Message	take a look inside your wheel well lip, it is at a 90 degree angle with about half an inch or so of sheetmetal....once rolled that sheetmetal, will be folded up against the backside of the ouward facing fender at more of an angle like 10 or so degrees "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." --Winston Churchill "The last official act of any government is to loot the treasury." --George Washington END THE FED ....learn why, in 42 minutes Full Pardon for PFC Bradley Manning
Follow Ups	Eastwood Fender Roller ??? - blackomega 11:17:22 05/14/12 It folds the flat edge of the wheel well into itself. - Woody75 (Denver) 11:28:28 05/14/12 weak (n/m) - blackomega 11:30:49 05/14/12 rolling vs pulling - Shiers69 11:39:30 05/14/12 Re: rolling vs pulling - blackomega 12:21:12 05/14/12 might as well get full tubs and some 2 ft wide slicks (n/m) - Shiers69 13:07:08 05/14/12 shaving a few mm is not as bad as you think - blackomega 13:25:08 05/14/12 yes, your local guy is correct - LJZTT 14:34:41 05/14/12
Post a Followup	You cannot reply to this message because you are not logged in.