Subject	Attn Ash: or someone that can explain this.
Posted by	PiotrC70 on May 12, 2012 at 12:33 PM
	This message has been viewed 755 times.
Message	In this pic below, the two lines that "T" behind the water lines go to where your PCV's used to be. And can also be seen here. My question is, are you running the single hose off of that "T" to your boost controller and capping the brass barb fitting that are on your pipe set that would NORMALLY run to the boost controller? In this pic, it's obvious that both sets of tubing (from the "T") and the BOV's, go/come from the plenum. Does this not matter which side of the throttle bodies you get your vacuum/boost reference? 1993 TT. R.I.P. 09.15.2010
Follow Ups	Attn Ash: or someone that can explain this. - PiotrC70 12:33:42 05/12/12 You should take boost readings - Rob'Z 12:43:45 05/12/12 Re: Attn Ash: or someone that can explain this. - MaxxAction 12:46:13 05/12/12 i have a similar PCV route - WhiTTe Z 13:07:18 05/12/12 I think you're missing his point. We have block off plugs - gunghoe9 13:46:00 05/12/12 I run a barb fitting in the same location for BOV's - SkiFly01 11:27:38 05/14/12
Post a Followup	You cannot reply to this message because you are not logged in.