Subject	Wouldn't it have been quicker/easier to just make a new
Posted by	dogpile on May 08, 2012 at 9:16 AM
	This message has been viewed 153 times.
In Reply To	A new LOWFATZ update. posted by Milo (SATX) on May 07, 2012 at 12:18 AM
Message	balance tube? Cut off the stock flanges, buy proper sized pipe, weld. Seems much less a pain than going nuts removing stuff on the plenum. Good job either way
Follow Ups	A new LOWFATZ update. - Milo (SATX) 00:18:49 05/07/12 Very nice!! - KongZTT GT28RS MD 00:27:00 05/07/12 impressed with the oil squirters - FuerGrissa 04:28:24 05/07/12 Thanks for posting. Awesome update. Very informative - Boosted1 06:20:13 05/07/12 a few questions... - aliaZ 07:39:29 05/07/12 Thanks for the link, Yeah, it's an impressive writeup. - Milo (SATX) 08:05:05 05/07/12 ok - aliaZ 08:44:30 05/07/12 I can see that being a concern. It was for me. But once - Milo (SATX) 14:35:02 05/07/12 Re: ok - Tech@EPR 17:23:55 05/07/12 When Chuck had the OS Gikens installed in the Evil Twin - sfarrah 09:13:40 05/07/12 ok thanks - aliaZ 09:40:29 05/07/12 Yup, these are simply the stock tranny gears. I knew the - Milo (SATX) 14:36:08 05/07/12 Re: a few questions... - Tech@EPR 17:26:16 05/07/12 Re: Re: a few questions... - aliaZ 18:37:20 05/07/12 Re: Re: Re: a few questions... - Tech@EPR 19:32:41 05/07/12 Re: Re: Re: Re: a few questions... - aliaZ 19:58:53 05/07/12 Re: Re: Re: Re: Re: a few questions... - Tech@EPR 21:17:23 05/07/12 Nice - Adam (NoVA) 07:42:55 05/07/12 Fantastic build... The high CR piston approach is a sweet - samsung-Z [Houston] 15:37:16 05/07/12 it's an NA (n/m) - aliaZ 18:37:55 05/07/12 :( the thrill is gone then..... - samsung-Z [Houston] 21:42:38 05/08/12 :| (n/m) - ZiNnYc 18:53:25 05/07/12 nice! (n/m) - Halo TTZ 21:33:41 05/07/12 Wouldn't it have been quicker/easier to just make a new - dogpile 09:16:13 05/08/12 Wow!!!! (n/m) - ConVerTT 21:51:47 05/08/12 Is it really ok to sandblast gears? - Jim (Selin Design) 01:54:31 05/09/12 Re: Is it really ok to sandblast gears? - Tech@EPR 05:18:57 05/09/12
Post a Followup	You cannot reply to this message because you are not logged in.