| Message |
There are a lot of ways you can do it, however the closer to combustion, the better. Also, I'd be concerned with the sensor heat-soaking in the cast-aluminum plenum a bit, but I am sure it's fine. On the left in this picture you can see it pre-TB 
Also, I thought those MAP sensors didn't do well with vibration? I didn't direct mount mine to the plenum because of this, I remote mounted mine with a cushion clamp!
- You can see it in the picture on the firewall, behind where the battery normally is.
____________________________________________________ 
"If Charlie Sheen quit doing cocaine - and a month later, he
died of a heart attack... Nobody would be surprised.". Same
thing with the VG: If the engine was tuned, stopped detting -
and a month later, cracked a wrist pin... Nobody would be
surprised. |
 |
