Subject	I've removed just about everything I didnt take a pic of.
Posted by	Evan(CA) on April 21, 2012 at 7:17 PM
	This message has been viewed 204 times.
In Reply To	CAS, gauge cluster, ECU. (n/m) posted by DVDBURN (MD) on April 21, 2012 at 07:04 PM
Message	Should the CAS center cection pull in and out ~1/8"? Any way to verify the CAS works short of swapping it into a running car? I got the other stuff.
Follow Ups	Before I send this car off the to the junk yard are there - Evan(CA) 15:51:19 04/21/12 at a glance... - Adam (NoVA) 16:16:16 04/21/12 There are a lot of parts worth salvaging - s3trios 16:23:10 04/21/12 Well... - Evan(CA) 16:46:39 04/21/12 Re: Well... - Adam (NoVA) 21:45:05 04/21/12 You're doing it wrong... - Bernie (NoVA) 20:51:02 04/22/12 Was that Robo's car? - Evan(CA) 23:13:30 04/22/12 No - but I don't really understand the logic you're appling - Bernie (NoVA) 10:51:45 04/23/12 Well had it been Robo's Car my thinking was that was - Evan(CA) 15:55:17 04/23/12 Also, a lot of little stuff u wont get much for. - ZXoltan 16:25:51 04/21/12 Should that CAS have any in-out play? - Evan(CA) 16:54:30 04/21/12 Might work, but I wouldnt run it on my own car - ZXoltan 06:43:51 04/22/12 If you can get to it I could use - Jayru 16:37:24 04/21/12 Catalytic converters. (n/m) - 240Z FeO2 17:47:46 04/21/12 Most of the under carriage has been stripped. - Evan(CA) 17:51:56 04/21/12 Heat shield over trans. Do want - BlackholeZ 02:35:46 04/22/12 I'd buy the n/a speed sensor on the trans. (n/m) - treese88 18:19:48 04/21/12 IGNORE ME! Just realized it is auto...duh. (n/m) - treese88 18:39:53 04/21/12 CAS, gauge cluster, ECU. (n/m) - DVDBURN (MD) 19:04:51 04/21/12 I've removed just about everything I didnt take a pic of. - Evan(CA) 19:17:01 04/21/12 That sounds kinda sloppy. May still work ok when mounted - DVDBURN (MD) 21:13:35 04/21/12 I would say doors and hatch if they're not bent. (n/m) - AsaHerring 19:32:36 04/21/12 Vultures.... z32 style with an eye for easy pickin's (n/m) - Gordo 93TT Daytona 21:32:37 04/21/12 ill take the spoiler if you can get it off (n/m) - 4Zwin 00:58:16 04/22/12 Would you happen to have both gauge pods? - cHiNgLeZ 01:28:40 04/22/12 spoilers doors and t tops have value alone - Dane (Houston) 01:55:58 04/22/12 Cut out the body harness from fender to fender... - PiotrC70 10:33:58 04/22/12 *don't* cut body harnesses - remove them whole & intact - Bernie (NoVA) 10:56:55 04/23/12 yep, it would take me years to check out Ashley's - vorpalZ 13:53:32 04/23/12
Post a Followup	You cannot reply to this message because you are not logged in.