Subject	Should that CAS have any in-out play?
Posted by	Evan(CA) on April 21, 2012 at 4:54 PM
	This message has been viewed 194 times.
In Reply To	Also, a lot of little stuff u wont get much for. posted by ZXoltan on April 21, 2012 at 04:25 PM
Message	It spins freely but will pull out ~1/8" The rear wiper is cracked. I know there are other parts I could technically sell but I'm not sure if it's worth the effort. Cowl panels are cracked. To go through the trouble of removing the entire from of the engine for 40 bucks credit at Z1 doesn't really seem worth it. I may still pull the plenum, and TB's we'll see.
Follow Ups	Before I send this car off the to the junk yard are there - Evan(CA) 15:51:19 04/21/12 at a glance... - Adam (NoVA) 16:16:16 04/21/12 There are a lot of parts worth salvaging - s3trios 16:23:10 04/21/12 Well... - Evan(CA) 16:46:39 04/21/12 Re: Well... - Adam (NoVA) 21:45:05 04/21/12 You're doing it wrong... - Bernie (NoVA) 20:51:02 04/22/12 Was that Robo's car? - Evan(CA) 23:13:30 04/22/12 No - but I don't really understand the logic you're appling - Bernie (NoVA) 10:51:45 04/23/12 Well had it been Robo's Car my thinking was that was - Evan(CA) 15:55:17 04/23/12 Also, a lot of little stuff u wont get much for. - ZXoltan 16:25:51 04/21/12 Should that CAS have any in-out play? - Evan(CA) 16:54:30 04/21/12 Might work, but I wouldnt run it on my own car - ZXoltan 06:43:51 04/22/12 If you can get to it I could use - Jayru 16:37:24 04/21/12 Catalytic converters. (n/m) - 240Z FeO2 17:47:46 04/21/12 Most of the under carriage has been stripped. - Evan(CA) 17:51:56 04/21/12 Heat shield over trans. Do want - BlackholeZ 02:35:46 04/22/12 I'd buy the n/a speed sensor on the trans. (n/m) - treese88 18:19:48 04/21/12 IGNORE ME! Just realized it is auto...duh. (n/m) - treese88 18:39:53 04/21/12 CAS, gauge cluster, ECU. (n/m) - DVDBURN (MD) 19:04:51 04/21/12 I've removed just about everything I didnt take a pic of. - Evan(CA) 19:17:01 04/21/12 That sounds kinda sloppy. May still work ok when mounted - DVDBURN (MD) 21:13:35 04/21/12 I would say doors and hatch if they're not bent. (n/m) - AsaHerring 19:32:36 04/21/12 Vultures.... z32 style with an eye for easy pickin's (n/m) - Gordo 93TT Daytona 21:32:37 04/21/12 ill take the spoiler if you can get it off (n/m) - 4Zwin 00:58:16 04/22/12 Would you happen to have both gauge pods? - cHiNgLeZ 01:28:40 04/22/12 spoilers doors and t tops have value alone - Dane (Houston) 01:55:58 04/22/12 Cut out the body harness from fender to fender... - PiotrC70 10:33:58 04/22/12 *don't* cut body harnesses - remove them whole & intact - Bernie (NoVA) 10:56:55 04/23/12 yep, it would take me years to check out Ashley's - vorpalZ 13:53:32 04/23/12
Post a Followup	You cannot reply to this message because you are not logged in.