Subject	I had a similar problem a few months back
Posted by	Jayru on April 19, 2012 at 7:23 AM
	This message has been viewed 147 times.
In Reply To	my heart just broke posted by mikehawkhertz on April 18, 2012 at 10:57 PM
Message	My Jspec would not line up at the "kink" where it meets the fenders. It was actually dropped an inch on one side as well. I had it in my garage attic and I think the summer heat had warped it. I struggled for hours and had to loosen all brackets and keep pulling, bending, and even shave a bit in the kink area. Eventually I got it to fit to where I was happy. The funny thing is while I was going through it, I started looking at cars with Jspec's online and a lot of the bumpers fit pretty terribly! I don't think you really notice till your trying to put it on your own car. Good luck! 90 Twin Turbo Track Build - jsworks.org for more info!
Follow Ups	my heart just broke - mikehawkhertz 22:57:23 04/18/12 Urethane parts bend and shape over time - Kennymonster 23:58:07 04/18/12 no i had it laying normally in my garage - mikehawkhertz 00:05:46 04/19/12 You can try leaving it out in the sun - Kennymonster 00:26:24 04/19/12 I had a similar problem a few months back - Jayru 07:23:41 04/19/12 thanks for the replies! - mikehawkhertz 15:10:15 04/19/12 a heat gun works magic (n/m) - DualZ (SF) 12:41:04 04/19/12 I 2nd this :) (n/m) - Coldfusown 14:25:15 04/19/12 Try loosing the bolt that attached the fender to under/ next - CmyZ 19:45:00 04/19/12
Post a Followup	You cannot reply to this message because you are not logged in.