TwinTurbo.NET: Nissan 300ZX forum - That is pretty extreme. I had mine cut and adjusted to fit
People Seeking Info
 
   


     
Subject That is pretty extreme. I had mine cut and adjusted to fit
     
Posted by Gordo 93TT Daytona on March 07, 2012 at 5:49 PM
  This message has been viewed 336 times.
     
In Reply To Be warned: The tips stick out crazy far. posted by SeedyROM on March 07, 2012 at 03:53 PM
     
Message This is the normal Borla fit. The pipes do extend some from the bodywork, but my complaint was they hung too low. There is about a 2" gap between the pipe tips and the lower facia edge.

The exhaust pipes were shortened in front of the muffler about a 1/2". This pulled them nicely back into the body

Then the hangers were cut and re-welded to raise the pipe tips closer to the body work. The gap between the facia and the pipe tips was reduced from 2" to 1/2". Total Cost: $100

_________________________________________________



     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.