Subject	CR steel would work, but could have corrosion issues
Posted by	zellamay on March 05, 2012 at 4:29 PM
	This message has been viewed 72 times.
In Reply To	A question to all the machinists/metalurgy guys posted by MrOzzie5183 on March 05, 2012 at 01:04 PM
Message	in the future. It's also much easier to machine than stainless, so make an extra set. Don't use round bar stock, for reasons already mentioned. For the amount you need, material cost should not be a factor. Find a scrap yard, or better yet go to a local machine shop and buy the piece you need. Since you'll be paying in cash, they might give you a super deal on a piece laying around.
Follow Ups	A question to all the machinists/metalurgy guys - MrOzzie5183 13:04:22 03/05/12 Assuming I'm not giving advice to a future competitor....... - Rob'Z 15:12:33 03/05/12 You would probably want to use sheet for the plates instead - LitlElvis 15:17:37 03/05/12 CR steel would work, but could have corrosion issues - zellamay 16:29:54 03/05/12
Post a Followup	You cannot reply to this message because you are not logged in.