Subject	You would probably want to use sheet for the plates instead
Posted by	LitlElvis on March 05, 2012 at 3:17 PM
	This message has been viewed 74 times.
In Reply To	A question to all the machinists/metalurgy guys posted by MrOzzie5183 on March 05, 2012 at 01:04 PM
Message	of trying to slice them off of a rod.
Follow Ups	A question to all the machinists/metalurgy guys - MrOzzie5183 13:04:22 03/05/12 Assuming I'm not giving advice to a future competitor....... - Rob'Z 15:12:33 03/05/12 You would probably want to use sheet for the plates instead - LitlElvis 15:17:37 03/05/12 CR steel would work, but could have corrosion issues - zellamay 16:29:54 03/05/12
Post a Followup	You cannot reply to this message because you are not logged in.