Subject	Assuming I'm not giving advice to a future competitor.......
Posted by	Rob'Z on March 05, 2012 at 3:12 PM
	This message has been viewed 118 times.
In Reply To	A question to all the machinists/metalurgy guys posted by MrOzzie5183 on March 05, 2012 at 01:04 PM
Message	Brass won't gall the aluminum like steel or another piece of aluminum can. SS might work, I've seen this used on OEM and some other applications, my prototype set used SS throttle plates. You don't want to make your plates from a rod unless your saw is AWESOMELY straight and leaves a smooth cut (unlikely). You want to cut them from a sheet of 1.5mm or 1/16". There's more detail than just a round disc btw. Good luck on your project. Rob SRC="http://ttp://i31.photobucket.com/albums/c359/RobZ90TT/AZR%201 0/beyondsig.jpg">
Follow Ups	A question to all the machinists/metalurgy guys - MrOzzie5183 13:04:22 03/05/12 Assuming I'm not giving advice to a future competitor....... - Rob'Z 15:12:33 03/05/12 You would probably want to use sheet for the plates instead - LitlElvis 15:17:37 03/05/12 CR steel would work, but could have corrosion issues - zellamay 16:29:54 03/05/12
Post a Followup	You cannot reply to this message because you are not logged in.