Subject	If a mechanic only tightens 2 lugnuts on a wheel
Posted by	JayT (Tampa,FL) on March 01, 2012 at 4:30 PM
	This message has been viewed 110 times.
In Reply To	They did not "bypass the safety switch" posted by TriniTT on March 01, 2012 at 04:10 PM
Message	to cut corners and save time/money instead installing/tightening all 5, and that very same wheel comes off because all 5 weren't installed/tightened correctly, is it the mechanics fault or the customers fault who had no knowledge about the half ass job?
Follow Ups	Would a mechanic know if a Z had a remote car start if... - JayT (Tampa,FL) 11:10:08 03/01/12 If all the wiring for it was done under the dash, no. - dogpile 11:17:41 03/01/12 Tach wire is sometimes found in the engine compartment (n/m) - Forced1(NYC) 13:03:04 03/01/12 Yeah, that is what I had to run for the Sentra to work. - dogpile 13:21:28 03/01/12 I would doubt any mechanic would know unless you told them. - PiotrC70 11:21:35 03/01/12 I told him about it - JayT (Tampa,FL) 11:26:14 03/01/12 If the remote start was wired properly it should have never - JUNz (?00)rwhp 11:46:38 03/01/12 This. - dogpile 11:52:14 03/01/12 Could any of these switches be disconnected during a - JayT (Tampa,FL) 11:55:27 03/01/12 Re: Could any of these switches be disconnected during a - JUNz (?00)rwhp 12:41:13 03/01/12 Isn't the wiring harness changed when doing a 5speed conv.? (n/m) - JayT (Tampa,FL) 11:28:28 03/01/12 Also, isn't an ECU swap required when converting the trany? (n/m) - JayT (Tampa,FL) 12:51:23 03/01/12 Not auto to 5spd. 5sp to auto you would need one. (n/m) - Woody75 (Denver) 13:34:58 03/01/12 shrug (n/m) - Bernie (NoVA) 11:33:33 03/01/12 When doing a motor install/conversion, it would seem unusual - TriniTT 14:35:00 03/01/12 It happened at his shop.. - JayT (Tampa,FL) 15:41:24 03/01/12 The real question is why the start button was pushed - dogpile 15:46:35 03/01/12 Was a stock clutch. Does it matter why the remote start - JayT (Tampa,FL) 16:00:04 03/01/12 It shouldn't have, but it was. - dogpile 16:06:19 03/01/12 I think a more important question was - JayT (Tampa,FL) 16:14:15 03/01/12 They did not "bypass the safety switch" - TriniTT 16:10:48 03/01/12 I expected - JayT (Tampa,FL) 16:21:17 03/01/12 absolutely not. - Antihero 16:48:56 03/01/12 The clutch engagement safety switch has nothing to do - JayT (Tampa,FL) 16:58:07 03/01/12 clutch interlock is US spec, Canadian cars don't have this - aliaZ 07:15:37 03/02/12 If a mechanic only tightens 2 lugnuts on a wheel - JayT (Tampa,FL) 16:30:01 03/01/12 Neutral safety switch is the key to a remote start - chicagozer 15:50:02 03/01/12 Re: Remote car start - diamond20601 23:03:11 03/01/12
Post a Followup	You cannot reply to this message because you are not logged in.