Subject	The real question is why the start button was pushed
Posted by	dogpile on March 01, 2012 at 3:46 PM
	This message has been viewed 96 times.
In Reply To	It happened at his shop.. posted by JayT (Tampa,FL) on March 01, 2012 at 03:41 PM
Message	if it wasn't meant to be started. And I disagree on the negligence of the bypassed clutch switch thing. It's a known/debated fact that a heavier aftermarket clutch can/will cause wear on a certain bearing if it's pushed without the motor running. LOTS of cars, mine included, have that switch bypassed for years (a calender decade for my car) with or without remote starters. Which leads back to my original comment this time: why was the start button pushed if the car wasn't meant to be pushed?
Follow Ups	Would a mechanic know if a Z had a remote car start if... - JayT (Tampa,FL) 11:10:08 03/01/12 If all the wiring for it was done under the dash, no. - dogpile 11:17:41 03/01/12 Tach wire is sometimes found in the engine compartment (n/m) - Forced1(NYC) 13:03:04 03/01/12 Yeah, that is what I had to run for the Sentra to work. - dogpile 13:21:28 03/01/12 I would doubt any mechanic would know unless you told them. - PiotrC70 11:21:35 03/01/12 I told him about it - JayT (Tampa,FL) 11:26:14 03/01/12 If the remote start was wired properly it should have never - JUNz (?00)rwhp 11:46:38 03/01/12 This. - dogpile 11:52:14 03/01/12 Could any of these switches be disconnected during a - JayT (Tampa,FL) 11:55:27 03/01/12 Re: Could any of these switches be disconnected during a - JUNz (?00)rwhp 12:41:13 03/01/12 Isn't the wiring harness changed when doing a 5speed conv.? (n/m) - JayT (Tampa,FL) 11:28:28 03/01/12 Also, isn't an ECU swap required when converting the trany? (n/m) - JayT (Tampa,FL) 12:51:23 03/01/12 Not auto to 5spd. 5sp to auto you would need one. (n/m) - Woody75 (Denver) 13:34:58 03/01/12 shrug (n/m) - Bernie (NoVA) 11:33:33 03/01/12 When doing a motor install/conversion, it would seem unusual - TriniTT 14:35:00 03/01/12 It happened at his shop.. - JayT (Tampa,FL) 15:41:24 03/01/12 The real question is why the start button was pushed - dogpile 15:46:35 03/01/12 Was a stock clutch. Does it matter why the remote start - JayT (Tampa,FL) 16:00:04 03/01/12 It shouldn't have, but it was. - dogpile 16:06:19 03/01/12 I think a more important question was - JayT (Tampa,FL) 16:14:15 03/01/12 They did not "bypass the safety switch" - TriniTT 16:10:48 03/01/12 I expected - JayT (Tampa,FL) 16:21:17 03/01/12 absolutely not. - Antihero 16:48:56 03/01/12 The clutch engagement safety switch has nothing to do - JayT (Tampa,FL) 16:58:07 03/01/12 clutch interlock is US spec, Canadian cars don't have this - aliaZ 07:15:37 03/02/12 If a mechanic only tightens 2 lugnuts on a wheel - JayT (Tampa,FL) 16:30:01 03/01/12 Neutral safety switch is the key to a remote start - chicagozer 15:50:02 03/01/12 Re: Remote car start - diamond20601 23:03:11 03/01/12
Post a Followup	You cannot reply to this message because you are not logged in.