Subject	Re: Could any of these switches be disconnected during a
Posted by	JUNz (?00)rwhp on March 01, 2012 at 12:41 PM
	This message has been viewed 113 times.
In Reply To	Could any of these switches be disconnected during a posted by JayT (Tampa,FL) on March 01, 2012 at 11:55 AM
Message	The only 1-wire that could have been disconnected or cut during the tranny swap is the E-brake signal wire, but i see no reason to mess with it since the ebrake has nothing to do with any of the conversion. On my 91 5spd car the "neutral safety switch wire is attached to the wire from the ECU and the E-brake wire to the trigger wire of the ebrake.
Follow Ups	Would a mechanic know if a Z had a remote car start if... - JayT (Tampa,FL) 11:10:08 03/01/12 If all the wiring for it was done under the dash, no. - dogpile 11:17:41 03/01/12 Tach wire is sometimes found in the engine compartment (n/m) - Forced1(NYC) 13:03:04 03/01/12 Yeah, that is what I had to run for the Sentra to work. - dogpile 13:21:28 03/01/12 I would doubt any mechanic would know unless you told them. - PiotrC70 11:21:35 03/01/12 I told him about it - JayT (Tampa,FL) 11:26:14 03/01/12 If the remote start was wired properly it should have never - JUNz (?00)rwhp 11:46:38 03/01/12 This. - dogpile 11:52:14 03/01/12 Could any of these switches be disconnected during a - JayT (Tampa,FL) 11:55:27 03/01/12 Re: Could any of these switches be disconnected during a - JUNz (?00)rwhp 12:41:13 03/01/12 Isn't the wiring harness changed when doing a 5speed conv.? (n/m) - JayT (Tampa,FL) 11:28:28 03/01/12 Also, isn't an ECU swap required when converting the trany? (n/m) - JayT (Tampa,FL) 12:51:23 03/01/12 Not auto to 5spd. 5sp to auto you would need one. (n/m) - Woody75 (Denver) 13:34:58 03/01/12 shrug (n/m) - Bernie (NoVA) 11:33:33 03/01/12 When doing a motor install/conversion, it would seem unusual - TriniTT 14:35:00 03/01/12 It happened at his shop.. - JayT (Tampa,FL) 15:41:24 03/01/12 The real question is why the start button was pushed - dogpile 15:46:35 03/01/12 Was a stock clutch. Does it matter why the remote start - JayT (Tampa,FL) 16:00:04 03/01/12 It shouldn't have, but it was. - dogpile 16:06:19 03/01/12 I think a more important question was - JayT (Tampa,FL) 16:14:15 03/01/12 They did not "bypass the safety switch" - TriniTT 16:10:48 03/01/12 I expected - JayT (Tampa,FL) 16:21:17 03/01/12 absolutely not. - Antihero 16:48:56 03/01/12 The clutch engagement safety switch has nothing to do - JayT (Tampa,FL) 16:58:07 03/01/12 clutch interlock is US spec, Canadian cars don't have this - aliaZ 07:15:37 03/02/12 If a mechanic only tightens 2 lugnuts on a wheel - JayT (Tampa,FL) 16:30:01 03/01/12 Neutral safety switch is the key to a remote start - chicagozer 15:50:02 03/01/12 Re: Remote car start - diamond20601 23:03:11 03/01/12
Post a Followup	You cannot reply to this message because you are not logged in.