Subject	on a sidenote, I have experienced this pseudo-rev-limiter
Posted by	LJZTT on February 28, 2012 at 4:17 PM
	This message has been viewed 121 times.
In Reply To	A REAL big hole would act like a bad MAF posted by ZXoltan on February 26, 2012 at 05:59 PM
Message	that happens when you have a major leak. I left a t-bolt clamp untightened on a hardpipe, IIRC by the driver side throttle body. Later, driving the same TT with the same mods, one of the IC duct bolts from my Greddy IC's (12 or 14mm) somehow worked its way loose and fell out, leaving a bolt-sized threaded hole in the end tank. The car ran just like normal but with a huge power loss and a very audible whistle when in boost. Go figure "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." --Winston Churchill "The last official act of any government is to loot the treasury." --George Washington END THE FED ....learn why, in 42 minutes Full Pardon for PFC Bradley Manning
Follow Ups	Any feedback on je pistons? - Thenumber1z 10:28:28 02/26/12 I had the JE pistons.... - samsungZ [Houston] 12:43:44 02/26/12 That kinda stuff scares me. - new2boost 15:02:18 02/26/12 J&S knock controller is the cure IMHO. - samsungZ [Houston] 15:13:25 02/26/12 I saw the post on it and its on my mod list. - new2boost 15:40:37 02/26/12 What did you use for power supply for the J&S? (n/m) - toykoz32 18:09:54 02/26/12 1 of the 12vdc supplies off the efi harness by the ecu. (n/m) - samsungZ [Houston] 19:01:03 02/26/12 Just asking because the installation guide says to hook - toykoz32 21:15:26 02/26/12 2x widebands and 2x EGT (one on each bank).. - KongZTT GT28RS MD 16:12:21 02/27/12 Yea, it will TELL you something is wrong, BUT - samsungZ [Houston] 19:36:20 02/27/12 going to look into it :) (n/m) - KongZTT GT28RS MD 19:24:09 02/28/12 an unknown hole in the IC will cause it to run rich not lean - aliaZ 16:02:03 02/26/12 ....... - samsungZ [Houston] 17:25:27 02/26/12 "An" does not equal "And". Learn proper spelling already... (n/m) - Aqualung 17:56:47 02/26/12 Bad enough that I was writing - samsungZ [Houston] 19:18:34 02/26/12 That's not a valid excuse. Nice try though. (n/m) - Aqualung 12:02:38 02/27/12 . - samsungZ [Houston] 19:27:10 02/27/12 . - Aqualung 10:49:16 02/28/12 Fyi >> - ztunerz 18:06:40 02/26/12 >> - samsungZ [Houston] 18:51:29 02/26/12 Re: an unknown hole in the IC will cause it to run rich not lean - Xteam300TT (South Tx ) 21:15:31 02/26/12 It would (n/m) - ztunerz 21:55:44 02/26/12 True (n/m) - ForceFedTT (SoCal) 02:30:58 02/27/12 yes (n/m) - aliaZ 06:36:36 02/27/12 everyone knows he is full of it, so just let him blabber - LJZTT 16:10:07 02/28/12 That hole in your IC must have been pretty big. (n/m) - ForceFedTT (SoCal) 17:37:52 02/26/12 A REAL big hole would act like a bad MAF - ZXoltan 17:59:48 02/26/12 on a sidenote, I have experienced this pseudo-rev-limiter - LJZTT 16:17:08 02/28/12 pretty massive, directly underneath it... - samsungZ [Houston] 18:54:50 02/26/12 Re: Any feedback on je pistons? - Thenumber1z 17:25:19 02/26/12 Re: Any feedback on je pistons? - Thenumber1z 19:12:13 02/26/12 Get a motor from kyle at IPP. (n/m) - JonnyZ(SoCal) 21:10:57 02/26/12
Post a Followup	You cannot reply to this message because you are not logged in.