Subject	2x widebands and 2x EGT (one on each bank)..
Posted by	KongZTT GT28RS MD on February 27, 2012 at 4:12 PM
	This message has been viewed 121 times.
In Reply To	J&S knock controller is the cure IMHO. posted by samsungZ [Houston] on February 26, 2012 at 03:13 PM
Message	Will immediately tell you if there is a problem. _________________________________________________________________________ ~~~ Sig starts below ~~~ ================================================================= NO, This picture is not photoshopped. MySpace for those who have em' AIM:Shawn300zxTT "-Any closeups on the nuts? - zboost(tx) 19:17:53 08/08/05 -Not really something you want to ask another man about... (n/m) - LordZ 19:24:00 08/08/05" "I just took 45 min and scrubbed the heck out of my rear" teambushido(San Diego, CA) 19:24:51 12/11/04 -1991 Stage _ TT 5spd (Upgraded to hell and back) -1990 Super White 2+2 Na Stage 3 Auto (Deceased :( ) -1990 Cherry Red Pearl ,Auto Coupe (Parts car) -1990 11 Sec Eagle Talon Tsi AWD, (SOLD!) -2001 Ford F-150 Crew cab, 5.4 Triton v8.. Tow bitch -1997 Acura 2.2 CL, 5spd. Daily Driver.. great little car! -2004 Honda CBR 600RR (Candy blue, FOR SALE)
Follow Ups	Any feedback on je pistons? - Thenumber1z 10:28:28 02/26/12 I had the JE pistons.... - samsungZ [Houston] 12:43:44 02/26/12 That kinda stuff scares me. - new2boost 15:02:18 02/26/12 J&S knock controller is the cure IMHO. - samsungZ [Houston] 15:13:25 02/26/12 I saw the post on it and its on my mod list. - new2boost 15:40:37 02/26/12 What did you use for power supply for the J&S? (n/m) - toykoz32 18:09:54 02/26/12 1 of the 12vdc supplies off the efi harness by the ecu. (n/m) - samsungZ [Houston] 19:01:03 02/26/12 Just asking because the installation guide says to hook - toykoz32 21:15:26 02/26/12 2x widebands and 2x EGT (one on each bank).. - KongZTT GT28RS MD 16:12:21 02/27/12 Yea, it will TELL you something is wrong, BUT - samsungZ [Houston] 19:36:20 02/27/12 going to look into it :) (n/m) - KongZTT GT28RS MD 19:24:09 02/28/12 an unknown hole in the IC will cause it to run rich not lean - aliaZ 16:02:03 02/26/12 ....... - samsungZ [Houston] 17:25:27 02/26/12 "An" does not equal "And". Learn proper spelling already... (n/m) - Aqualung 17:56:47 02/26/12 Bad enough that I was writing - samsungZ [Houston] 19:18:34 02/26/12 That's not a valid excuse. Nice try though. (n/m) - Aqualung 12:02:38 02/27/12 . - samsungZ [Houston] 19:27:10 02/27/12 . - Aqualung 10:49:16 02/28/12 Fyi >> - ztunerz 18:06:40 02/26/12 >> - samsungZ [Houston] 18:51:29 02/26/12 Re: an unknown hole in the IC will cause it to run rich not lean - Xteam300TT (South Tx ) 21:15:31 02/26/12 It would (n/m) - ztunerz 21:55:44 02/26/12 True (n/m) - ForceFedTT (SoCal) 02:30:58 02/27/12 yes (n/m) - aliaZ 06:36:36 02/27/12 everyone knows he is full of it, so just let him blabber - LJZTT 16:10:07 02/28/12 That hole in your IC must have been pretty big. (n/m) - ForceFedTT (SoCal) 17:37:52 02/26/12 A REAL big hole would act like a bad MAF - ZXoltan 17:59:48 02/26/12 on a sidenote, I have experienced this pseudo-rev-limiter - LJZTT 16:17:08 02/28/12 pretty massive, directly underneath it... - samsungZ [Houston] 18:54:50 02/26/12 Re: Any feedback on je pistons? - Thenumber1z 17:25:19 02/26/12 Re: Any feedback on je pistons? - Thenumber1z 19:12:13 02/26/12 Get a motor from kyle at IPP. (n/m) - JonnyZ(SoCal) 21:10:57 02/26/12
Post a Followup	You cannot reply to this message because you are not logged in.