Subject	Yup. When the hood cools it flexs a bit. Bend the bracket up (n/m)
Posted by	chicagozer on February 27, 2012 at 8:19 AM
	This message has been viewed 61 times.
In Reply To	again, most likely your hood switch is FUBAR. posted by Halo TTZ on February 27, 2012 at 06:30 AM
Message
Follow Ups	Alarm questions - new2boost 19:36:00 02/26/12 A few weeks ago mine started going off.... - samsungZ [Houston] 19:46:55 02/26/12 Thats the thing though, all my lights work - new2boost 19:58:52 02/26/12 Remind me to reschedule my boosting of your Z for - CoHPhasor 20:05:11 02/26/12 That's not factory - CoHPhasor 20:04:16 02/26/12 My guess is as good as yours... - samsungZ [Houston] 20:47:56 02/26/12 2nd that. It's not factory. (n/m) - ZTicket(Dallas) 09:24:06 02/27/12 . - Aqualung 12:06:03 02/27/12 FLICK or g.a.l.s. your choice. - samsungZ [Houston] 12:23:51 02/27/12 . - Aqualung 13:36:28 02/27/12 The hood switch is usually the problem. It's located - zellamay 20:30:47 02/26/12 +1 it's probably just bad though. - Jayru 20:38:37 02/26/12 Ive had the hood off and drove it around and didnt - new2boost 20:44:15 02/26/12 When the car is running it's not an issue - Jayru 21:01:04 02/26/12 Ok thank you, ill check into it. (n/m) - new2boost 21:30:42 02/26/12 Do you have your hood back on? (n/m) - sandmanz32 20:49:57 02/26/12 Yes sir. Just was redoing the claps on the boost tubes - new2boost 21:34:18 02/26/12 stock AFAIK, only goes off when the doors/hatch/hood - Halo TTZ 22:19:48 02/26/12 See the thing is i parked the car and locked the door and - new2boost 22:36:59 02/26/12 again, most likely your hood switch is FUBAR. - Halo TTZ 06:30:45 02/27/12 Yup. When the hood cools it flexs a bit. Bend the bracket up (n/m) - chicagozer 08:19:01 02/27/12 Ok then thats what ill do today. Thanks guys! (n/m) - new2boost 13:19:28 02/27/12 It takes about 1 minute to bend the hood switch bracket. (n/m) - zellamay 09:35:53 02/27/12 The FSM has a nice section dedicated to the stock anti-theft - JBender 10:57:36 02/27/12
Post a Followup	You cannot reply to this message because you are not logged in.