TwinTurbo.NET: Nissan 300ZX forum - yes (n/m)
Subject
yes (n/m)
Posted by
aliaZ
on February 27, 2012 at 6:36 AM
This message has been viewed
109
times.
In Reply To
Re: an unknown hole in the IC will cause it to run rich not lean
posted by Xteam300TT (South Tx )
on February 26, 2012 at 09:15 PM
Message
Follow Ups
Any feedback on je pistons?
-
Thenumber1z
10:28:28 02/26/12
I had the JE pistons....
-
samsungZ [Houston]
12:43:44 02/26/12
That kinda stuff scares me.
-
new2boost
15:02:18 02/26/12
J&S knock controller is the cure IMHO.
-
samsungZ [Houston]
15:13:25 02/26/12
I saw the post on it and its on my mod list.
-
new2boost
15:40:37 02/26/12
What did you use for power supply for the J&S? (n/m)
-
toykoz32
18:09:54 02/26/12
1 of the 12vdc supplies off the efi harness by the ecu. (n/m)
-
samsungZ [Houston]
19:01:03 02/26/12
Just asking because the installation guide says to hook
-
toykoz32
21:15:26 02/26/12
2x widebands and 2x EGT (one on each bank)..
-
KongZTT GT28RS MD
16:12:21 02/27/12
Yea, it will TELL you something is wrong, BUT
-
samsungZ [Houston]
19:36:20 02/27/12
going to look into it :) (n/m)
-
KongZTT GT28RS MD
19:24:09 02/28/12
an unknown hole in the IC will cause it to run rich not lean
-
aliaZ
16:02:03 02/26/12
.......
-
samsungZ [Houston]
17:25:27 02/26/12
"An" does not equal "And". Learn proper spelling already... (n/m)
-
Aqualung
17:56:47 02/26/12
Bad enough that I was writing
-
samsungZ [Houston]
19:18:34 02/26/12
That's not a valid excuse. Nice try though. (n/m)
-
Aqualung
12:02:38 02/27/12
.
-
samsungZ [Houston]
19:27:10 02/27/12
.
-
Aqualung
10:49:16 02/28/12
Fyi >>
-
ztunerz
18:06:40 02/26/12
>>
-
samsungZ [Houston]
18:51:29 02/26/12
Re: an unknown hole in the IC will cause it to run rich not lean
-
Xteam300TT (South Tx )
21:15:31 02/26/12
It would (n/m)
-
ztunerz
21:55:44 02/26/12
True (n/m)
-
ForceFedTT (SoCal)
02:30:58 02/27/12
yes (n/m) -
aliaZ
06:36:36 02/27/12
everyone knows he is full of it, so just let him blabber
-
LJZTT
16:10:07 02/28/12
That hole in your IC must have been pretty big. (n/m)
-
ForceFedTT (SoCal)
17:37:52 02/26/12
A REAL big hole would act like a bad MAF
-
ZXoltan
17:59:48 02/26/12
on a sidenote, I have experienced this pseudo-rev-limiter
-
LJZTT
16:17:08 02/28/12
pretty massive, directly underneath it...
-
samsungZ [Houston]
18:54:50 02/26/12
Re: Any feedback on je pistons?
-
Thenumber1z
17:25:19 02/26/12
Re: Any feedback on je pistons?
-
Thenumber1z
19:12:13 02/26/12
Get a motor from kyle at IPP. (n/m)
-
JonnyZ(SoCal)
21:10:57 02/26/12
Post a
Followup
You cannot reply to this message because you are not
logged in
.