TwinTurbo.NET: Nissan 300ZX forum - Re: an unknown hole in the IC will cause it to run rich not lean
Subject
Re: an unknown hole in the IC will cause it to run rich not lean
Posted by
Xteam300TT (South Tx )
on February 26, 2012 at 9:15 PM
This message has been viewed
163
times.
In Reply To
an unknown hole in the IC will cause it to run rich not lean
posted by aliaZ
on February 26, 2012 at 04:02 PM
Message
Wouldnt it run lean under vacumm and rich under boost ?
Follow Ups
Any feedback on je pistons?
-
Thenumber1z
10:28:28 02/26/12
I had the JE pistons....
-
samsungZ [Houston]
12:43:44 02/26/12
That kinda stuff scares me.
-
new2boost
15:02:18 02/26/12
J&S knock controller is the cure IMHO.
-
samsungZ [Houston]
15:13:25 02/26/12
I saw the post on it and its on my mod list.
-
new2boost
15:40:37 02/26/12
What did you use for power supply for the J&S? (n/m)
-
toykoz32
18:09:54 02/26/12
1 of the 12vdc supplies off the efi harness by the ecu. (n/m)
-
samsungZ [Houston]
19:01:03 02/26/12
Just asking because the installation guide says to hook
-
toykoz32
21:15:26 02/26/12
2x widebands and 2x EGT (one on each bank)..
-
KongZTT GT28RS MD
16:12:21 02/27/12
Yea, it will TELL you something is wrong, BUT
-
samsungZ [Houston]
19:36:20 02/27/12
going to look into it :) (n/m)
-
KongZTT GT28RS MD
19:24:09 02/28/12
an unknown hole in the IC will cause it to run rich not lean
-
aliaZ
16:02:03 02/26/12
.......
-
samsungZ [Houston]
17:25:27 02/26/12
"An" does not equal "And". Learn proper spelling already... (n/m)
-
Aqualung
17:56:47 02/26/12
Bad enough that I was writing
-
samsungZ [Houston]
19:18:34 02/26/12
That's not a valid excuse. Nice try though. (n/m)
-
Aqualung
12:02:38 02/27/12
.
-
samsungZ [Houston]
19:27:10 02/27/12
.
-
Aqualung
10:49:16 02/28/12
Fyi >>
-
ztunerz
18:06:40 02/26/12
>>
-
samsungZ [Houston]
18:51:29 02/26/12
Re: an unknown hole in the IC will cause it to run rich not lean -
Xteam300TT (South Tx )
21:15:31 02/26/12
It would (n/m)
-
ztunerz
21:55:44 02/26/12
True (n/m)
-
ForceFedTT (SoCal)
02:30:58 02/27/12
yes (n/m)
-
aliaZ
06:36:36 02/27/12
everyone knows he is full of it, so just let him blabber
-
LJZTT
16:10:07 02/28/12
That hole in your IC must have been pretty big. (n/m)
-
ForceFedTT (SoCal)
17:37:52 02/26/12
A REAL big hole would act like a bad MAF
-
ZXoltan
17:59:48 02/26/12
on a sidenote, I have experienced this pseudo-rev-limiter
-
LJZTT
16:17:08 02/28/12
pretty massive, directly underneath it...
-
samsungZ [Houston]
18:54:50 02/26/12
Re: Any feedback on je pistons?
-
Thenumber1z
17:25:19 02/26/12
Re: Any feedback on je pistons?
-
Thenumber1z
19:12:13 02/26/12
Get a motor from kyle at IPP. (n/m)
-
JonnyZ(SoCal)
21:10:57 02/26/12
Post a
Followup
You cannot reply to this message because you are not
logged in
.