Subject	pretty massive, directly underneath it...
Posted by	samsungZ [Houston] on February 26, 2012 at 6:54 PM
	This message has been viewed 143 times.
In Reply To	That hole in your IC must have been pretty big. (n/m) posted by ForceFedTT (SoCal) on February 26, 2012 at 05:37 PM
Message	hard to notice at a quick glance when installed.. I never drove over anything to the best of my knowledge... don't know how the heck it got there.... In any event, that was then, this is now... problems fixed, she's been on the road ever since. ~Mario D. -------------------------------------------------------------------- My current favorite TT.net member quotes: Nice, it's all fun and games until the turbos kick in :) (n/m) - Chickan 14:13:32 02/03/12 -------------------------------------------------------------------- My Siggy: "I don't know about yours, but my Z is a pus*y magnet :-P"
Follow Ups	Any feedback on je pistons? - Thenumber1z 10:28:28 02/26/12 I had the JE pistons.... - samsungZ [Houston] 12:43:44 02/26/12 That kinda stuff scares me. - new2boost 15:02:18 02/26/12 J&S knock controller is the cure IMHO. - samsungZ [Houston] 15:13:25 02/26/12 I saw the post on it and its on my mod list. - new2boost 15:40:37 02/26/12 What did you use for power supply for the J&S? (n/m) - toykoz32 18:09:54 02/26/12 1 of the 12vdc supplies off the efi harness by the ecu. (n/m) - samsungZ [Houston] 19:01:03 02/26/12 Just asking because the installation guide says to hook - toykoz32 21:15:26 02/26/12 2x widebands and 2x EGT (one on each bank).. - KongZTT GT28RS MD 16:12:21 02/27/12 Yea, it will TELL you something is wrong, BUT - samsungZ [Houston] 19:36:20 02/27/12 going to look into it :) (n/m) - KongZTT GT28RS MD 19:24:09 02/28/12 an unknown hole in the IC will cause it to run rich not lean - aliaZ 16:02:03 02/26/12 ....... - samsungZ [Houston] 17:25:27 02/26/12 "An" does not equal "And". Learn proper spelling already... (n/m) - Aqualung 17:56:47 02/26/12 Bad enough that I was writing - samsungZ [Houston] 19:18:34 02/26/12 That's not a valid excuse. Nice try though. (n/m) - Aqualung 12:02:38 02/27/12 . - samsungZ [Houston] 19:27:10 02/27/12 . - Aqualung 10:49:16 02/28/12 Fyi >> - ztunerz 18:06:40 02/26/12 >> - samsungZ [Houston] 18:51:29 02/26/12 Re: an unknown hole in the IC will cause it to run rich not lean - Xteam300TT (South Tx ) 21:15:31 02/26/12 It would (n/m) - ztunerz 21:55:44 02/26/12 True (n/m) - ForceFedTT (SoCal) 02:30:58 02/27/12 yes (n/m) - aliaZ 06:36:36 02/27/12 everyone knows he is full of it, so just let him blabber - LJZTT 16:10:07 02/28/12 That hole in your IC must have been pretty big. (n/m) - ForceFedTT (SoCal) 17:37:52 02/26/12 A REAL big hole would act like a bad MAF - ZXoltan 17:59:48 02/26/12 on a sidenote, I have experienced this pseudo-rev-limiter - LJZTT 16:17:08 02/28/12 pretty massive, directly underneath it... - samsungZ [Houston] 18:54:50 02/26/12 Re: Any feedback on je pistons? - Thenumber1z 17:25:19 02/26/12 Re: Any feedback on je pistons? - Thenumber1z 19:12:13 02/26/12 Get a motor from kyle at IPP. (n/m) - JonnyZ(SoCal) 21:10:57 02/26/12
Post a Followup	You cannot reply to this message because you are not logged in.