Subject	I left mine off, if you try to put it back in it blocks well
Posted by	LJZTT on February 26, 2012 at 5:13 PM
	This message has been viewed 113 times.
In Reply To	Installing Selin dual intake elbow kit posted by 1blackz on February 26, 2012 at 11:32 AM
Message	over half the front of the radiator intake area "Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery." --Winston Churchill "The last official act of any government is to loot the treasury." --George Washington END THE FED ....learn why, in 42 minutes Full Pardon for PFC Bradley Manning
Follow Ups	Installing Selin dual intake elbow kit - 1blackz 11:32:23 02/26/12 ?? "air deflector" ?? - MidLifeZ (DFW) 13:22:34 02/26/12 Re: ?? "air deflector" ?? - 1blackz 13:31:28 02/26/12 No, keep it there - outkaZTT 13:52:43 02/26/12 Ooopps!!!! - 1blackz 14:43:36 02/26/12 I dont even drive my Z in the rain. - new2boost 14:59:01 02/26/12 take a look at Ashley Powers' flower pot mod - sjomada 15:55:58 02/26/12 After switching from hard elbows to selin my filters sat - Wright (Ca) 15:01:03 02/26/12 I left mine off, if you try to put it back in it blocks well - LJZTT 17:13:40 02/26/12 Re: I left mine off, if you try to put it back in it blocks well - 1blackz 18:45:15 02/26/12 I kept the corrugated panel in place to shield the filters; - Gordo 93TT Daytona 20:23:53 02/26/12 Same thing I did. - Woody75 (Denver) 21:14:01 02/26/12 Re: Same thing I did. - 1blackz 21:53:31 02/26/12 Even if the panel is not needed for performance or water - 240Z FeO2 22:53:13 02/26/12 I left mine in place with no mods, but that is - Zblackbeast 08:26:47 02/27/12 I just cut a flat piece of carbon fiber and bolted - RICH1 09:10:04 02/27/12 I tried that but a lot still seemed to hang down really far - LJZTT 10:34:49 02/27/12 Leave it in place. (n/m) - Bernie (NoVA) 09:54:54 02/27/12 I took mine completely off with no problems... not much - Piranha 22:16:09 02/27/12
Post a Followup	You cannot reply to this message because you are not logged in.