Subject	No, keep it there
Posted by	outkaZTT on February 26, 2012 at 1:52 PM
	This message has been viewed 140 times.
In Reply To	Installing Selin dual intake elbow kit posted by 1blackz on February 26, 2012 at 11:32 AM
Message	You need to drill two small holes in it for each filter and bolt the filters in place. Assuming you have filters that have threads on the nose.
Follow Ups	Installing Selin dual intake elbow kit - 1blackz 11:32:23 02/26/12 ?? "air deflector" ?? - MidLifeZ (DFW) 13:22:34 02/26/12 Re: ?? "air deflector" ?? - 1blackz 13:31:28 02/26/12 No, keep it there - outkaZTT 13:52:43 02/26/12 Ooopps!!!! - 1blackz 14:43:36 02/26/12 I dont even drive my Z in the rain. - new2boost 14:59:01 02/26/12 take a look at Ashley Powers' flower pot mod - sjomada 15:55:58 02/26/12 After switching from hard elbows to selin my filters sat - Wright (Ca) 15:01:03 02/26/12 I left mine off, if you try to put it back in it blocks well - LJZTT 17:13:40 02/26/12 Re: I left mine off, if you try to put it back in it blocks well - 1blackz 18:45:15 02/26/12 I kept the corrugated panel in place to shield the filters; - Gordo 93TT Daytona 20:23:53 02/26/12 Same thing I did. - Woody75 (Denver) 21:14:01 02/26/12 Re: Same thing I did. - 1blackz 21:53:31 02/26/12 Even if the panel is not needed for performance or water - 240Z FeO2 22:53:13 02/26/12 I left mine in place with no mods, but that is - Zblackbeast 08:26:47 02/27/12 I just cut a flat piece of carbon fiber and bolted - RICH1 09:10:04 02/27/12 I tried that but a lot still seemed to hang down really far - LJZTT 10:34:49 02/27/12 Leave it in place. (n/m) - Bernie (NoVA) 09:54:54 02/27/12 I took mine completely off with no problems... not much - Piranha 22:16:09 02/27/12
Post a Followup	You cannot reply to this message because you are not logged in.