Subject	Is it possible that the removable rubber seal is not part
Posted by	CoHPhasor on February 23, 2012 at 5:22 PM
	This message has been viewed 76 times.
In Reply To	Quick Kingpin Arm Bearing Question posted by Jayru on February 23, 2012 at 11:32 AM
Message	of the bearing, but is instead supposed to be put back in after you replace the bearing? (Like a cover)
Follow Ups	Quick Kingpin Arm Bearing Question - Jayru 11:32:21 02/23/12 Sounds like an aftermarket bearing to me. (n/m) - Bernie (NoVA) 14:31:34 02/23/12 Which one Bernie, the sealed or open one? - Jayru 15:01:37 02/23/12 Open. (n/m) - Bernie (NoVA) 17:13:35 02/23/12 Think it's safe to use, or should I look into getting a new - Jayru 17:42:34 02/23/12 Is it possible that the removable rubber seal is not part - CoHPhasor 17:22:15 02/23/12 Definitely not a cover, It's a sealed lip on the bearing - Jayru 17:33:08 02/23/12 There was a early #change on the 90's up tp 7/90 production - Joe@ZSpeedperformance 21:25:36 02/23/12 Hi Joe - My car is a 90 Twin Turbo - Jayru 21:47:01 02/23/12 2/89 to 7/89 NA shows a different washer on top of the - Joe@ZSpeedperformance 21:30:26 02/23/12
Post a Followup	You cannot reply to this message because you are not logged in.