Subject	cut mine at a 45* angle, bolt still does its job,
Posted by	Z32TT-R on February 22, 2012 at 1:31 AM
	This message has been viewed 66 times.
In Reply To	I had made modifications to adapt it, this one posted by CoHPhasor on February 22, 2012 at 01:00 AM
Message	Issue resolved.
Follow Ups	folks with top feed rails>>> - MikeVar82 12:31:37 02/21/12 Re: folks with top feed rails>>> - megaDan 15:38:13 02/21/12 A tab? so its used as a ground? On stock rail it goes to a - MikeVar82 15:44:08 02/21/12 fuel temp sensor? (n/m) - BoneZ (MD) 16:23:25 02/21/12 "a tab" is an improper description, I have the WINFactory .. - CoHPhasor 17:21:39 02/21/12 You always have bad to say about your rail. Makes one wonder - Z32TT-R 20:32:18 02/21/12 More of a commentary on design, and besides - CoHPhasor 20:57:55 02/21/12 I have the 1st unit and mine is fine. - toykoz32 21:37:25 02/21/12 You didn't hear what I said - CoHPhasor 22:02:28 02/21/12 While I'm at it, I might as well mention that the FTS mount - CoHPhasor 22:09:15 02/21/12 Your funny - toykoz32 22:32:32 02/21/12 Hey dopey, did I say it was in the way of the lines? - CoHPhasor 22:48:56 02/21/12 why not shave it alil then? some shaving is required to fit. - Z32TT-R 23:34:12 02/21/12 Calm down - toykoz32 00:43:32 02/22/12 I had made modifications to adapt it, this one - CoHPhasor 01:00:15 02/22/12 cut mine at a 45* angle, bolt still does its job, - Z32TT-R 01:31:11 02/22/12 Meh. The piece is just tack-welded in place.. - CoHPhasor 01:36:51 02/22/12 fo sho. (n/m) - Z32TT-R 02:08:20 02/22/12 The other kit has modifications too (n/m) - toykoz32 00:44:24 02/22/12 Re: "a tab" is an improper description, I have the WINFactory .. - megaDan 09:41:26 02/22/12 Second (+_=) (n/m) - Ba11erz (MD) 20:08:26 02/21/12 Since the fuel temp sensor is a part of the PRVR system - LitlElvis 09:56:17 02/22/12
Post a Followup	You cannot reply to this message because you are not logged in.