Subject	I have the 1st unit and mine is fine.
Posted by	toykoz32 on February 21, 2012 at 9:37 PM
	This message has been viewed 125 times.
In Reply To	More of a commentary on design, and besides posted by CoHPhasor on February 21, 2012 at 08:57 PM
Message	The bung is just like factory. Factory does not go though to the fuel and never makes contact with fuel, so whats the problem? You wanted to look prettier? What defective materials? Like I said I have the 1st unit ( prototype ) I would like to hear about this.
Follow Ups	folks with top feed rails>>> - MikeVar82 12:31:37 02/21/12 Re: folks with top feed rails>>> - megaDan 15:38:13 02/21/12 A tab? so its used as a ground? On stock rail it goes to a - MikeVar82 15:44:08 02/21/12 fuel temp sensor? (n/m) - BoneZ (MD) 16:23:25 02/21/12 "a tab" is an improper description, I have the WINFactory .. - CoHPhasor 17:21:39 02/21/12 You always have bad to say about your rail. Makes one wonder - Z32TT-R 20:32:18 02/21/12 More of a commentary on design, and besides - CoHPhasor 20:57:55 02/21/12 I have the 1st unit and mine is fine. - toykoz32 21:37:25 02/21/12 You didn't hear what I said - CoHPhasor 22:02:28 02/21/12 While I'm at it, I might as well mention that the FTS mount - CoHPhasor 22:09:15 02/21/12 Your funny - toykoz32 22:32:32 02/21/12 Hey dopey, did I say it was in the way of the lines? - CoHPhasor 22:48:56 02/21/12 why not shave it alil then? some shaving is required to fit. - Z32TT-R 23:34:12 02/21/12 Calm down - toykoz32 00:43:32 02/22/12 I had made modifications to adapt it, this one - CoHPhasor 01:00:15 02/22/12 cut mine at a 45* angle, bolt still does its job, - Z32TT-R 01:31:11 02/22/12 Meh. The piece is just tack-welded in place.. - CoHPhasor 01:36:51 02/22/12 fo sho. (n/m) - Z32TT-R 02:08:20 02/22/12 The other kit has modifications too (n/m) - toykoz32 00:44:24 02/22/12 Re: "a tab" is an improper description, I have the WINFactory .. - megaDan 09:41:26 02/22/12 Second (+_=) (n/m) - Ba11erz (MD) 20:08:26 02/21/12 Since the fuel temp sensor is a part of the PRVR system - LitlElvis 09:56:17 02/22/12
Post a Followup	You cannot reply to this message because you are not logged in.