Subject	FWIW, I use the EVAP line that goes into the balance tube
Posted by	BlackholeZ on February 20, 2012 at 6:43 PM
	This message has been viewed 126 times.
In Reply To	Does this seem like a good Seafoam procedure? Does it work? posted by dutch_Z on February 20, 2012 at 03:21 PM
Message	I use a single line into that port, and hold it just above the level of fluid so that it "slurps" and doesn't take too much at once. -Dan BlackholeZ VTC Solenoid Caps and Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Does this seem like a good Seafoam procedure? Does it work? - dutch_Z 15:21:57 02/20/12 The "sea foam spray" section ive done a little differently - jmt-z 16:10:04 02/20/12 From what I've heard, that's a good sign - BlackholeZ 18:40:49 02/20/12 A variation on the spray method... - Eric(FL) 16:56:14 02/20/12 FWIW, I use the EVAP line that goes into the balance tube - BlackholeZ 18:43:00 02/20/12 You dont get the front cylinders using the balance tube. (n/m) - Woody75 (Denver) 22:38:14 02/20/12 ok then, nevermind - BlackholeZ 12:21:57 02/21/12 Just seafoam'd mine for the first time this weekend.. - HK'S Z 11:10:48 02/21/12
Post a Followup	You cannot reply to this message because you are not logged in.