TwinTurbo.NET: Nissan 300ZX forum - z surgery (n/m)
Subject
z surgery (n/m)
Posted by
ali300zx
on February 14, 2012 at 7:27 PM
This message has been viewed
180
times.
In Reply To
Use lights on the side, and over the engine bay....
posted by Gordo 93TT Daytona
on February 14, 2012 at 04:55 PM
Message
Follow Ups
Examples of Garage Lighting?
-
evan_aggie(ATX)
11:43:05 02/13/12
How many lights you're going to need depends on a bunch
-
240Z FeO2
12:45:33 02/13/12
2 car garage, standard depth. Ceilings... 8' I think.
-
evan_aggie(ATX)
13:50:06 02/13/12
Do a little bit of research. The longer bulbs may be more
-
240Z FeO2
18:39:25 02/13/12
In case you haven't been there yet -- >
-
cherry
12:55:57 02/13/12
More.
-
Bernie (NoVA)
13:02:02 02/13/12
Do you think the reflectors make a difference? (n/m)
-
evan_aggie(ATX)
13:45:16 02/13/12
With reflectors you can direct, or even focus, light
-
240Z FeO2
20:20:50 02/13/12
of course. (n/m)
-
Bernie (NoVA)
00:07:48 02/14/12
Here's what I did: Cost me $100 and 15 minutes...
-
GodZilla (KY)
13:18:27 02/13/12
I did this
-
1911a1
14:38:42 02/13/12
An older pic
-
Rob'Z
15:27:38 02/13/12
I've tried to light my garage like a paint booth...
-
Fly-Surf
16:01:33 02/13/12
Is there a reason you went with recessed versus FL pods? (n/m)
-
evan_aggie(ATX)
16:05:29 02/13/12
Cheap,low profile, clearance, clean look...
-
Fly-Surf
16:28:46 02/13/12
Do it right or don't do it at all ;)
-
300twinz (satx)
16:27:25 02/13/12
Rich people don't believe in 2 car garages? (n/m)
-
Milo (SATX)
23:56:05 02/13/12
Go with high output 8ft T12 bulbs
-
timz
16:53:37 02/13/12
Agree. I have 6 8' HO bulbs. (2 per fixture) and it
-
ShakaShaun(Denver)
17:20:48 02/13/12
my cheapy set up.
-
Halo TTZ
18:10:04 02/13/12
That's not bad. I have also been thinking about
-
Milo (SATX)
23:57:48 02/13/12
I just hate the cords hanging.
-
Halo TTZ
09:16:47 02/15/12
Use lights on the side, and over the engine bay....
-
Gordo 93TT Daytona
16:55:36 02/14/12
z surgery (n/m) -
ali300zx
19:27:07 02/14/12
Post a
Followup
You cannot reply to this message because you are not
logged in
.