Subject	Re: Will this rad support be usable or a nightmare to swap?
Posted by	thomasfortney on February 12, 2012 at 2:46 PM
	This message has been viewed 89 times.
In Reply To	Will this rad support be usable or a nightmare to swap? posted by Jkova300z on February 12, 2012 at 12:12 PM
Message	You should be able to use that just fine. You should get a spot weld drill bit though, using a normal drill bit is not the correct way to do it. You just want to drill through the top layer, so that the bottom layer (the rad support) is all solid, so that you just do plug welds. You may also need a 90 degree drill to get in those corners.
Follow Ups	Will this rad support be usable or a nightmare to swap? - Jkova300z 12:12:55 02/12/12 I would say yes - Jayru 13:55:35 02/12/12 Re: Will this rad support be usable or a nightmare to swap? - thomasfortney 14:46:46 02/12/12 make sure it matches your car TT vs NA are not the same. (n/m) - Bernie (NoVA) 00:19:29 02/13/12
Post a Followup	You cannot reply to this message because you are not logged in.